FUEL SYSTEM
PB-8010, EB810
29
4-6 Replacing carburetor
Removing
1. Remove intake pipe.
2. Remove carburetor cover (A).
3. Disconnect throttle cable from carburetor.
4. Pull off outer fuel line and fuel return line from
carburetor.
5. Loosen two bolts (B) and remove air duct and
cleaner fi xture (C), intake gasket (D) and carbure-
tor (E) from the unit.
Installing
1. Install new intake gasket (F).
2. Install carburetor (E).
3. Install new intake gasket (D).
NOTE:
Two intake gaskets (D) and (F) are not
same, take care not to mix the gaskets.
4. Reassemble all removed parts.
A
B
C
D
F
E
To Next Page
Loading...
