Echo shindaiwa PB-8010 - Replacing Starter Rope

STARTER SYSTEM
PB-8010, EB810
9
2-2 Replacing starter rope
1. Pull out knot (c1) from starter grip and untie knot
(c1).
2. Pull knot (c2) to remove rope from rope reel.
3. When installing a new starter rope, singe both
ends of the rope to prevent fraying.
4. Make a knot (c2) at end of starter rope and pass
the rope through hole of rope reel, then push the
knot (c2) into recess as shown.
5. Pass the other end of starter rope (C) through
starter case (K) from inside to outside.
6. Pass starter rope (C) through starter grip (N)
and grip cap (P). Make a knot (c1) as shown.
7. Push the knot (c1) into recess of grip cap (P).
c1
c2
c2
c2
c1
c1
K
C
N
P
P