Echo shindaiwa PB-8010 - Disassembling and Assembling Fan; Replacing Fan Case

BLOWER SYSTEM
PB-8010, EB810
43
6-3 Disassembling and assembling fan
1. Install clean rope into spark plug hole (Refer to
“3-10 Inspecting and replacing magneto rotor”).
2. Remove fan nut (A) using 14mm socket wrench
counterclockwise.
3. Thread Fan remover 91087 (B) on crankshaft
end.
4. Lift up Fan remover (B).
5. Strike the end of Fan remover 91087 (B) with a
hammer squarely as shown.
6. Replace fan if defective.
7. Tighten fan nut (A) using 14mm socket wrench
clockwise.
A
A
B
6-4 Replacing fan case
1. Remove engine side fan case (A) from guard
side fan case (B) (Refer to “6-1 Separating fan
case assembly”).
2. Replace guard side fan case if defective (Refer
to “5-1 Removing backpack frame assembly”).
3. When removing engine from engine side fan
case (A), remove fan from engine side fan case (A)
fi rst. Then loosen fi ve bolts.
4. Replace engine side fan case if defective.
A
B