BLOWER SYSTEM
PB-8010, EB810
44
6-4 Replacing fan case (continued)
Assembling fan case
5. Place engine plate (H) and fan (J) on engine
side fan case (A).
6. Hook nails parts of engine side fan case (A) on
engine plate (H) as shown.
7. Assemble fan and engine side fan case (A) (Refer
to “6-3 Disassembling and assembling fan”).
8. When installing engine on engine side fan case
(A) with fi ve bolts, fasten stop switch ground lead
(C) shown as white arrow.
NOTE:
Apply 2-stroke oil on stop switch ground
lead (c:yellow dotted line) and fasten stop switch
ground lead (C) in parallel with projection (a3).
9. Make sure projection (a1) of engine side fan
case (A) is inserted in hole (d) of spacer (D).
10. Install springs (E) and spring holders (F) to
engine side fan case (A).
NOTE:
Joint of springs (E) and engine side fan
case (a2) should be no gap. Joint of springs (E)
and spring holders (F) should be no gap.
11. Assemble engine side fan case (A) and engine
to guard side fan case (B).
12. Slide and insert spring holders (F) into slots (g)
on backpack frame.
13. Tighten 11 tapping bolts in order shown.
14. Reassemble all removed parts (Refer to “6-1
Separating fan case assembly”).
D
d
A
B
g
No gap
E
F
a2
View arrow
d
a1
A
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
g
A
J
Hook nails parts
H
C
a3
c
To Next Page
Loading...
