BACKPACK FRAME
PB-8010, EB810
37
5-1 Removing backpack frame assembly
1. Remove four precoated bolts (K) and washers.
NOTE:
When retighten the precoated bolts (K),
replace new ones or apply thread locking sealant
ThreeBond #1324N.
If old thread locking sealant is left in threads, cor-
rect torque may not be secured. In case old thread
locking sealant is left, remove it.
2. Remove two tapping bolts (L).
3. Pull up head of clip (M) as shown to remove the
clip.
4. Remove back cushion (E) from backpack frame.
5. Remove three tapping bolts (N).
6. Remove bolt (P).
7. Remove fuel tank band and fuel tank.
8. Slide spring holders (Q) forward as shown to
remove fan case assembly from backpack frame
assembly.
NOTE:
Spring holders (Q) easily slide out of back-
pack frame slots.
K
L
ME
N
P
Q
Q
To Next Page
Loading...
