IGNITION SYSTEM
PB-8010, EB810
20
3-6 Replacing ignition switch (continued)
10. Connect throttle cable to carburetor (Refer to
“4-14 Checking and adjusting throttle cable”).
11. Connect primary wire (A) and (P)
12. Connect ground wire (B) and (Q).
13. Bind primary wire terminal (a1), ground wire
terminal (b1) and control cable (R) with clip (S).
14.Secure the clip (S) to fan case with bolt.
15. Put primary wire (A) into ribs of intake insulator
as shown.
NOTE:
Make sure not to contact primary wire (A)
and debris guard (T).
16. Route control cable assembly (G) as shown.
17. Put control cable assembly (G) into groove on
engine cover as shown.
18. Reassemble all removed parts.
P
A
B
Q
a1
b1
R
S
S
A
T
G
G
To Next Page
Loading...
