IGNITION SYSTEM
PB-8010, EB810
19
3-6 Replacing ignition switch (continued)
Installing
1. If replacing bolt (J) and nut (K) stored in the ca-
ble connector, insert them into the groove until the
nut is fully seated.
2. Install control cable assembly (G) into the
groove of the cable connector (H) as shown.
3. Install ignition switch (L) into the groove.
4. Fit the primary wire and ground wire in the
groove.
5. Pinch clip (M) on the rubber part (N).
6. Install cable connector (H) and bolt (J) with con-
trol cable assembly (G) into the groove.
7. Instrall throttle trigger (F) with torsion spring (Q).
Make sure the end of the torsion spring (Q) is fully
seated in the handle grip.
8. Connect throttle cable (c2) to the trigger (F).
9. Put together both grip halves and tighten them
with four screws.
11 mm (0.4 inch)
J
K
H
G
L
M
H
G
J
M
N
F
c2
Q
To Next Page
Loading...
