STARTER SYSTEM
PB-8010, EB810
11
2-3 Installing rewind spring (Continued)
6) Continue to turn rope reel (D) counterclock-
wise until the outer hook (m2) of rewind spring is
caught on the small bolt or bar (S) as shown.
7) While holding rope reel fi rmly to keep rewind
spring winded, bind outside of winded rewind
spring with strong string, such as cable tie (T)
fi rmly not to unwind the spring.
8) Remove rope reel and rewind spring (M) gen-
tly.
9) Cut off the rest (t1) of cable tie.
10) Apply small amount of lithium based grease
to outside of rewind spring (M) and shaft of starter
case (K).
11) Align outer hook (m2) of spring with holder (k1)
of starter case.
12) Push rewind spring (M) down into the bot-
tom of case, keeping the spring strongly pressed
against case.
13) Spring (M) should fall into starter case and
cable tie (T) can be removed.
NOTE:
Rewind spring supplied as spare part is shipped in temporary retainer. Install the spring and re-
move the retainer as above step 11) to 13).
m2
D
t1
T
lithium based
grease
K
M
k1
m2
m2
T
K
M
To Next Page
Loading...
