The Bluetooth hands-free function
47
IX
Registering using a cell phone
If a cell phone is currently connected, it must be
disconnected prior to registration of additional
cell phones.
ATTENTION
"NO ENTRY" will be displayed if available. If
not, a double beep will be heard if the phone
registration memory is not available or full.
The "Waiting" message appears on
the display.
The name of this unit is ECLIPSE BT.
ATTENTION
• For details on how to operate the cell
phone, read its instruction manual.
• Be sure to perform the registration of the
cell phone only while the "Waiting" message
is on the display.
The default passcode is 1234.
ATTENTION
For details on how to operate the cell phone,
read its instruction manual.
The cell phone has been registered.
( and appear on the display.)
If the registration has not been
successfully completed, the "FAILED"
message appears on the display.
Repeat the registration procedure.
ATTENTION
• To register another cell phone to the main
unit, press the [ /BAND] button twice after
Step 7. Perform the registration procedure
from the registered cell phone selection
mode in Step 1.
• You cannot register an already registered
phone number again.
• Both hands-free function and the audio
function may be connected at the same
time for some cell phones. In such a case,
register the hands-free function of the cell
phone first.
1
In the Phone Setting selection
mode, select "Registration" by
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Select "Allow Connect" by
pressing the [ ] or [ ] button.
4
Press the [ENTER] button.
5
Use the cell phone to select the
main unit name.
6
Use the cell phone to input the
passcode.
7
When the registration has been
completed, "COMPLETED" will be
displayed.
To Next Page
Loading...
Need help?
General
