Eclipse CD5030 User Manual

Making changes with Function Mode
81
XIV
Setting spectrum analyzer
sensitivity (S/A Sensitivity)
The sensitivity of the spectrum analyzer display
can be changed.
The spectrum analyzer sensitivity
setting mode is activated.
When the button is pressed, the
spectrum analyzer sensitivity changes
in the following order.
Hi ↔ Mid ↔ Low ↔ Hi ↔ www
The selected settings will take effect.
ATTENTION
The spectrum analyzer display is initially set to
the "Mid" (Middle) sensitivity.
Setting the steering remote
function (U.S.A. only)
The CD5030 supports two types of function
setup: (1) Automatic assignment of steering
remote functions to the steering switch buttons
using the steering remote data you have
downloaded from the ECLIPSE Web site (E-
iSERV), and (2) Manual assignment of steering
remote functions to the steering switch buttons
using the downloaded data. The steering remote
functions installed at the factory before shipment
cannot operate this main unit.
1
Select "S/A Sensitivity" by
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Select the sensitivity of the
spectrum analyzer by pressing the
[ ] or [ ] button.
4
Press the [ENTER] button.

Eclipse CD5030 Specifications

General

Brand	Eclipse
Model	CD5030
Category	Car Receiver
Language	English