74
Various Settings
Multi-harmonizer settings
(Harmonizer)
This function uses harmonic synthesis to restore
the high-frequency component that is lost as a
result of the compression process, so that
fresher sound can be obtained during MP3/
WMA, USB memory playback.
The harmonizer setting mode is
activated.
When the button is pressed, the
setting item changes in the following
order.
www ↔ OFF ↔ Hi ↔ Low ↔ www
Hi:
High effectiveness
Low:
Low effectiveness
The selected settings will take effect.
Non-fader settings (Non-F
Setting)
• Non-Fader Output (Output)
Non-Fader Output can be stereo or mono.
Select the method that matches the output
method for the sub-woofer system that is
connected to the main unit.
• Non-fader phase (Phase)
The merging of sound between the front and
rear speakers and the woofer can be
improved by selecting the phase. Switch the
phase to a phase which lets the speakers
combine without any disharmony.
The non-fader setting mode is
activated.
Non-Fader Output settings (Output)
[]:
Stereo
[]:
Monaural
Non-fader phase settings (Phase)
[]:
Normal
[]:
Reverse
1
Select "Multi-Harmonizer" by
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Select a setting item by pressing
the [ ] or [ ] button.
1
Select "Non-Fader" by pressing
the [ ] or [ ] button.
2
Press the [ENTER] button.
1
Press the [ ] button to select
"Output".
2
Select "Stereo" or "Monaural" by
pressings the [ ] or [ ] button.
1
Press the [ ] button to select
"Phase".
2
Select "Normal" or "Reverse" by
pressing the [ ] or [ ] button.
To Next Page
Loading...
Need help?
General
