34
Operation
How to operate the tuner
ATTENTION
• If stations have been stored in memory,
pressing a button from [1] to [6] will directly
select a station. (Refer to "Manually setting
stations into memory" on page 35)
Listening to the tuner
For details, refer to "Switching Audio
Modes" on page 17.
Tuning to a station
There are automatic and manual methods for
setting stations in memory. The main unit will
accept up to 24 stations in memory: 6 in AM 18 in
FM (6 each for FM1, FM2 and FM3.) (Initial
setting)
Radio bands will switch from FM1 →
FM2 → FM3 → AM in order each time
the button is pressed.
Right:
Tunes to higher frequencies.
Left:
Tunes to lower frequencies.
Right
:
Starts searching toward higher
frequencies.
Left:
Starts searching toward lower
frequencies.
ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals’ strength.
Other factors affecting reception include
interference from natural obstacles, sign posts,
etc.
When an optional HD Radio tuner unit is
connected, digital broadcasts have reception
priority. (U.S.A. only)
Operations during rotary mode
For the operation method in the Rotary mode,
refer to page 18.
1
Switch to tuner mode.
1
Press the [RTN/BAND] button for
less than one second to switch to
the desired FM, AM bands.
2
Press the [SELECT] (Right/Left)
button to tune to a station.
3
Press and hold the [SELECT]
(Right/Left) button to start the
automatic station search.
To Next Page
Loading...
Need help?
General
