Making changes with Function Mode
71
XIII
ATTENTION
The clock display can also be turned on and off
by pressing the button [6] while the power is
turned off.
Setting time (Clock Adjust)
This main unit uses the 12-hour display notation.
The clock setting mode is activated.
Right: Minutes will be switched.
Left: Hours will be switched.
Upper: Turns the time forward.
Lower: Turns the time back.
Switching demonstration
screen display (Demo)
Demonstration screen display settings can be
performed.
If the demonstration screen display is set to ON,
operation, motion picture, and other screens will
be displayed in succession.
If you press a button while the demonstration
screens are being displayed, the demonstration
screens will be canceled and the audio operation
screen will be displayed. If you do not operate
the status display function within 15 seconds, the
display will return automatically to the demo
screen.
The demo display setting mode is
activated.
ATTENTION
The demonstration screen display is set to ON
as a factory default. It is recommended that
you turn the demonstration screen display
OFF after installing the main unit.
4
Press the [CUSTOM/MENU] or
[RTN] button to exit function mode.
1
Press the [SELECT] (Upper/Lower)
button to select the Clock Adjust.
2
Press the [ENTER] button.
3
Press the [SELECT] (Right/Left)
button to display the item to be
selected for adjustment.
4
Press the [SELECT] (Upper/Lower)
button to adjust the time.
5
Press the [ENTER] button.
6
Press the [CUSTOM/MENU] or
[RTN] button to exit function mode.
1
Press the [SELECT] (Upper/ Lower)
button to select the Demo.
2
Press the [ENTER] button.
3
Press the [SELECT] (Upper/ Lower)
button to select the Demo ON/OFF.
4
Press the [CUSTOM/MENU] or
[RTN] button to exit function mode.
To Next Page
Loading...
Need help?
General
