Eclipse CD7100 - Multi-Harmonizer Settings (Harmonizer); Non-Fader Settings (Non-F Setting); Non-Fader Phase Settings (Phase)

60
Various Settings
Multi-harmonizer settings
(Harmonizer)
This function uses harmonic synthesis to restore
the high-frequency component that is lost as a
result of the compression process so that fresher
sound can be obtained during MP3 /WMA, USB
memory playback.
The harmonizer setting mode is
activated.
When the button is pressed, the
setting item changes in the following
order.
 ↔ Low ↔ Hi ↔ OFF ↔ 
Hi: High effectiveness
Low: Low effectiveness
The selected settings will take effect.
Non-fader settings (Non-F
Setting)
• Non-fader phase (Phase)
The merging of sound between the front and
rear speakers and the woofer can be
improved by selecting the phase. Switch the
phase to a phase which lets the speakers
combine without any disharmony.
• Non-Fader Output (Output)
Non-Fader Output can be stereo or mono.
Select the method that matches the output
method for the sub-woofer system that is
connected to the main unit.
The non-fader setting mode is
activated.
Non-fader phase settings (Phase)
Right: Reverse
Left: Normal
1
Press the [SELECT] (Upper/ Lower)
button to select the Harmonizer.
2
Press the [ENTER] button.
3
Press the [SELECT] (Upper/ Lower)
button to select the setting item.
4
Press the [CUSTOM/MENU] or
[RTN] button to exit sound
adjustment mode.
1
Press the [SELECT] (Upper/ Lower)
button to select the NF Setting.
2
Press the [ENTER] button.
1
Press the [SELECT] (Upper) button
to select the Phase.
2
Press the [SELECT] (Right/Left)
button to select Normal or
Reverse.
3
Press the [CUSTOM/MENU] or
[RTN] button to exit sound
adjustment mode.