Eclipse CD7100 User Manual

ESN security operating procedure
39
VIII
ESN security operating procedure
About ESN
This main unit is equipped with ESN (ECLIPSE
Security Network). A preregistered music CD
(Key CD) on which all main unit functions will not
operate, even by turning the ignition switch to the
ACC or ON position or reconnecting the battery
after turning the ignition switch off or
disconnecting the battery during maintenance.
ESN can be set or canceled using any of the
following methods:
• Key CD security
You can record a specific CD that you have as a
"key CD" with the main unit, and this CD can then
be used to set and cancel the security settings.
How to operate the ESN (Key
CD) security
How to program the Key CD
A [SEC] message appears, in two
seconds it will change to [DISC].
ATTENTION
• If a CD has already been inserted, a [SEC]
message appears, and then the front panel
opens and the CD is ejected.
• If a security is activated, programming the
Key CD is not available.
The front panel opens; The CD7100 is
now ready for your Key CD in the CD
slot.
A [SEC] message appears, then the
Key CD is ejected.
The front panel closes.
ATTENTION
• If there is a problem with the inserted CD,
an [ERR] message will appear for two
seconds and the CD will be ejected.
Reinsert the ejected CD.
• If a CD causes the [ERR] message to
appear twice in a row, a [CHANGE]
message will appear for two seconds. Try
another CD.
•
Copy Protected CD and MP3/WMA CD-ROM
cannot be programmed for Key CD security.
• The Security indicator will flash whenever
the vehicle's ignition is switched off.
How to cancel the Key CD
A [SEC] message appears, then in two
seconds it will change to [DISC].
The front panel opens; The CD7100 is
now ready for your Key CD in the CD
slot.
1
Check that the main unit is in
standby.
2
Press and hold the button [6], then
[SCREEN] button, and hold both
for more than one second.
3
Press the [ (OPEN/EJECT)]
button.
4
Insert the CD into the slot.
5
Press the [ (OPEN/EJECT)]
button.
1
Check that the main unit is in
standby.
2
Press and hold the button [6], then
[SCREEN] button, and hold both
for more than one second.
3
Press the [ (OPEN/EJECT)]
button.
VII

Eclipse CD7100 Specifications

General

Brand	Eclipse
Model	CD7100
Category	Car Receiver
Language	English