Ecom ST User Manual

ecom-ST 1.0 37
7.2 Data connection to the PC
If the device is connected to a PC, measured values can be recorded with
PC software from ecom.
The following software solutions are available:
• ecom-DAS NT 2
• ecom-DAS 5
7.2.1 ecom-DAS NT2
In addition to the data logger recording, the data can also be transferred
directly to the PC software "ecom-DAS NT 2" while the measuring operation
is running.
The USB interfaces can be used for communication with the software. The
transmission speed and the protocol are predefined for smooth
communication between the device and the DAS NT 2 PC software via the
USB interface.
To enable communication with the DAS NT 2 PC software, the following
settings must be made in the Settings / Internal / USB menu:
Parameter
Adjustment field
Adjustment for DAS NT 2
Transfer speed
1200 Baud − 115200 Baud
1200 Baud
Protocol
DAS = DAS NT 2
Enhanced = DAS 5
---- = none
DAS
NOTE
A driver is required for the communication between the device and
the DAS NT 2 PC software via the USB interface.
Download under: https://www.ecom.de/kundendienst/downloads/

Ecom ST Specifications

General

Brand	Ecom
Model	ST
Category	Measuring Instruments
Language	English