Ecom ST User Manual

38 ecom-ST 1.0
7.2.2 ecom-DAS 5
The software "ecom-DAS 5" can be used for the display and logging of
measured values and measured value progressions. Measurement data can
be exchanged between the software and the device via the SD card. A
recording of point measurements and course measurements during the
measuring operation can be implemented via USB.
The transmission speed and the protocol are predefined for smooth
communication between the device and the DAS 5 PC software via the USB
interface.
7.3 ecomModbus
To integrate the ecom-ST into your existing software, please use the
ecomModbus documentation.
Parameter
Adjustment field
Adjustment for DAS 5
Transfer speed
1200 Baud − 115200 Baud
1200 Baud − 38400 Baud
Protocol
DAS = DAS NT 2
Enhanced = DAS 5
---- = none
Enhanced
NOTE
A driver is required for the communication between the device and
the DAS 5 PC software via the USB interface.
Download under: https://www.ecom.de/kundendienst/downloads/

Ecom ST Specifications

General

Brand	Ecom
Model	ST
Category	Measuring Instruments
Language	English