H100B Pulse Oximeter User Manual
- 10 -
The sensor is applied to the patient;
The patient’s SpO
2
, Pulse rate are being
reported;
No error conditions exist.
4 Wash the probe with clean water after
disinfecting it to remove any remaining solution.
The probe can only be reused after dried
thoroughly.
5 Do not disinfect the probe with the water boiled.
6 Any residue should be removed from the probe
before being disinfected, and avoid contacting
corrosive solvent. Dipping the cable into alcohol
or alkalescent solvent for a long time may
reduce the flexibility of the scarfskin of the cable.
Also, the connector should not be dipped.
7 After monitoring, disinfect the probe according
to the instruction described in the user manual.
8 The materials with which the patient or any
other person can come into contact conform
with the standard of ISO10993.
9 The pictures and interfaces in this manual are
for reference only.
To Next Page
Loading...
