Edge-Core ES3510 - Figure 3-93 Configuring a VLAN Static Table

Configuring the Switch
3-150
3
which must be the same as the Port VID. See “Configuring VLAN Behavior for
Interfaces” on page 3-152
for configuring PVID.
- Forbidden: Interface is forbidden from automatically joining the VLAN via
GVRP. For more information, see “Automatic VLAN Registration” on page
3-144.
- None: Interface is not a member of the VLAN. Packets associated with this
VLAN will not be transmitted by the interface.
- Trunk Member – Indicates if a port is a member of a trunk. To add a trunk to the
selected VLAN, use the last table on the VLAN Static Table page.
Web – Click VLAN, 802.1Q VLAN, Static Table. Select a VLAN ID from the
scroll-down list. Modify the VLAN name and status if required. Select the
membership type by marking the appropriate radio button in the list of ports or
trunks. Click Apply.
Figure 3-93 Configuring a VLAN Static Table
CLI – The following example adds tagged and untagged ports to VLAN 2.
Console(config)#interface ethernet 1/1 4-150
Console(config-if)#switchport allowed vlan add 2 tagged 4-229
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport allowed vlan add 2 untagged
Console(config-if)#exit
Console(config)#interface ethernet 1/13
Console(config-if)#switchport allowed vlan add 2 tagged