Edge-Core ES3510 - Authentication Commands

Authentication Commands
4-79
4
Authentication Commands
You can configure this switch to authenticate users logging into the system for
management access using local or RADIUS authentication methods. You can also
enable port-based authentication for network client access using IEEE 802.1X.
Authentication Sequence
authentication login
This command defines the login authentication method and precedence. Use the no
form to restore the default.
Syntax
authentication login {[local] [radius] [tacacs]}
no authentication login
• local - Use local password.
• radius - Use RADIUS server password.
• tacacs - Use TACACS server password.
Default Setting
Local
Command Mode
Global Configuration
Table 4-28 Authentication Commands
Command Group Function Page
Authentication Sequence Defines logon authentication method and precedence 4-79
RADIUS Client Configures settings for authentication via a RADIUS server 4-81
TACACS+ Client Configures settings for authentication via a TACACS+ server 4-85
AAA Configures authentication, authorization, and accounting for
network access
4-89
Port Security Configures secure addresses for a port 4-98
Port Authentication Configures host authentication on specific ports using 802.1X 4-99
Network Access Configures MAC authentication and dynamic VLAN assignment 4-108
Web Authentication Configures Web authentication 4-115
Table 4-29 Authentication Sequence
Command Function Mode Page
authentication login Defines logon authentication method and precedence GC 4-79
authentication enable Defines the authentication method and precedence for
command mode change
GC 4-80