Edge-Core ES3510 - Displaying LLDP Local Device Information; Figure 3-107 LLDP Local Device Information

Configuring the Switch
3-174
3
CLI – This example sets the interface to both transmit and receive LLDP messages,
enables SNMP trap messages, enables MED notification, and specifies the TLV,
MED-TLV, dot1-TLV and dot3-TLV parameters to advertise.
Displaying LLDP Local Device Information
Use the LLDP Local Device Information screen to display information about the
switch, such as its MAC address, chassis ID, management IP address, and port
information.
Web – Click LLDP, Local Information.
Figure 3-107 LLDP Local Device Information
Console(config)#interface ethernet 1/1 4-150
Console(config-if)#lldp admin-status tx-rx 4-184
Console(config-if)#lldp notification 4-184
Console(config-if)#lldp medNotification 4-185
Console(config-if)#lldp basic-tlv port-description 4-186
Console(config-if)#lldp basic-tlv system-description 4-187
Console(config-if)#lldp basic-tlv management-ip-address 4-186
Console(config-if)#lldp basic-tlv system-name 4-188
Console(config-if)#lldp basic-tlv system-capabilities 4-187
Console(config-if)#lldp medtlv extPoe 4-192
Console(config-if)#lldp medtlv inventory 4-193
Console(config-if)#lldp medtlv location 4-193
Console(config-if)#lldp medtlv med-cap 4-194
Console(config-if)#lldp medtlv network-policy 4-194
Console(config-if)#lldp dot1-tlv proto-ident 4-188
Console(config-if)#lldp dot1-tlv proto-vid 4-189
Console(config-if)#lldp dot1-tlv pvid 4-189
Console(config-if)#lldp dot1-tlv vlan-name 4-190
Console(config-if)#lldp dot3-tlv link-agg 4-190
Console(config-if)#lldp dot3-tlv mac-phy 4-191
Console(config-if)#lldp dot3-tlv max-frame 4-191
Console(config-if)#lldp dot3-tlv poe 4-192
Console(config-if)#