Edge-Core ES3510 - Authorization Exec

Command Line Interface
4-96
4
- tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server
host command described on page 4-85.
- server-group - Specifies the name of a server group configured with the
aaa group server command described on 4-89. (Range: 1-255
characters)
Default Setting
Authorization is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
• This command performs authorization to determine if a user is allowed to run
an Exec shell.
• AAA authentication must be enabled before authorization is enabled.
• If this command is issued without a specified named method, the default
method list is applied to all interfaces or lines (where this authorization type
applies), except those that have a named method explicitly defined.
Example
authorization exec
This command applies an authorization method to local console or Telnet
connections. Use the no form to disable authorization on the line.
Syntax
authorization exec {default | list-name}
no authorization exec
• default - Specifies the default method list created with the aaa
authorization exec command (page 4-95).
• list-name - Specifies a method list created with the aaa authorization exec
command.
Default Setting
None
Command Mode
Line Configuration
Console(config)#aaa authorization exec default group tacacs+
Console(config)#