Command Line Interface
4-316
4
show cluster candidates
This command shows the discovered Candidate switches in the network.
Command Mode
Privileged Exec
Example
UPnP Commands
Universal Plug and Play (UPnP) is a set of protocols that allows devices to connect
seamlessly and simplifies the deployment of home and office networks. UPnP
achieves this by issuing UPnP device control protocols designed upon open,
Internet-based communication standards.
upnp device
This command enables UPnP on the device. Use the no form to disable UPnP.
Syntax
[no] upnp device}
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
You must enable UPnP before you can configure time out settings for sending
of UPnP messages.
Console#show cluster candidates
Cluster Candidates:
Role Mac Description
--------------- ----------------- -----------------------------------------
ACTIVE MEMBER 00-12-cf-23-49-c0 24/48 L2/L4 IPV4/IPV6 GE Switch
CANDIDATE 00-12-cf-0b-47-a0 24/48 L2/L4 IPV4/IPV6 GE Switch
Console#
Table 4-1. UPnP Commands
Command Function Mode Page
upnp device Enables/disables UPnP on the network GC 4-200
upnp device ttl Sets the time-to-live (TTL) value. GC 4-201
upnp device advertise
duration
Sets the advertisement duration of the device GC 4-201
show upnp Displays UPnP status and parameters PE 4-202
To Next Page
Loading...
