Edge-Core ES3510 - Telnet Server Commands; Ip Telnet Port; Ip Telnet Server; Table 4-15 Telnet Server Commands

Command Line Interface
4-42
4
Telnet Server Commands
ip telnet port
This command specifies the TCP port number used by the Telnet interface. Use the
no form to use the default port.
Syntax
ip telnet port port-number
no ip telnet port
port-number - The TCP port to be used by the browser interface.
(Range: 1-65535)
Default Setting
23
Command Mode
Global Configuration
Example
Related Commands
ip telnet server (4-42)
ip telnet server
This command allows this device to be monitored or configured from Telnet. Use the
no form to disable this function.
Syntax
[no] ip telnet server
Default Setting
Enabled
Command Mode
Global Configuration
Example
Table 4-15 Telnet Server Commands
Command Function Mode Page
ip telnet port Specifies the port to be used by the Telnet interface GC 4-39
ip telnet server Allows the switch to be monitored or configured from Telnet GC 4-39
Console(config)#ip telnet port 123
Console(config)#
Console(config)#ip telnet server
Console(config)#