Edge-Core ES3510 - Boot System

Command Line Interface
4-78
4
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (Range: 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-76)
whichboot (4-77)
Console(config)#boot system config: startup
Console(config)#