Edge-Core ES3510 - Configuring MVR Interface Status; Figure 3-142 MVR Group IP Information

Multicast VLAN Registration
3-223
3
Web – Click MVR, Group IP Information.
Figure 3-142 MVR Group IP Information
CLI – This example following shows information about the interfaces associated with
multicast groups assigned to the MVR VLAN.
Configuring MVR Interface Status
Each interface that participates in the MVR VLAN must be configured as an MVR
source port or receiver port. If only one subscriber attached to an interface is
receiving multicast services, you can enable the immediate leave function.
Command Usage
• One or more interfaces may be configured as MVR source ports.
• MVR receiver ports cannot be members of a trunk. Receiver ports can belong to
different VLANs, but should not be configured as a member of the MVR VLAN.
• IGMP snooping can be used to allow a source port or receiver port to dynamically
join or leave multicast groups within the MVR VLAN using the standard rules for
multicast filtering. Multicast groups can also be statically assigned to a source port
or receiver port (see “Assigning Static Multicast Groups to Interfaces” on page
3-225).
Console#show mvr interface 4-294
MVR Group IP Status Members
---------------- -------- -------
225.0.0.1 ACTIVE eth1/1(d), eth1/2(s)
225.0.0.2 INACTIVE None
225.0.0.3 INACTIVE None
225.0.0.4 INACTIVE None
225.0.0.5 INACTIVE None
225.0.0.6 INACTIVE None
225.0.0.7 INACTIVE None
225.0.0.8 INACTIVE None
225.0.0.9 INACTIVE None
225.0.0.10 INACTIVE None
Console#