Edge-Core ES3510 - Lldp Dot1-Tlv Proto-VID; Lldp Dot1-Tlv Pvid

LLDP Commands
4-189
4
Syntax
[no] lldp
dot1-tlv proto-ident
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the protocols that are accessible through this interface.
Example
lldp dot1-tlv proto-vid
This command configures an LLDP-enabled port to advertise port related VLAN
information. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-vid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the port-based and protocol-based VLANs configured
on this interface (see “Configuring VLAN Interfaces” on page 4-225 and
“Configuring Protocol-based VLANs” on page 4-242).
Example
lldp dot1-tlv pvid
This command configures an LLDP-enabled port to advertise its default VLAN ID.
Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv pvid
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-ident
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-vid
Console(config-if)#