LLDP Commands
4-191
4
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the
link, and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.
Example
lldp dot3-tlv mac-phy
This command configures an LLDP-enabled port to advertise its MAC and physical
layer capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises MAC/PHY configuration/status which includes
information about auto-negotiation support/capabilities, and operational
Multistation Access Unit (MAU) type.
Example
lldp dot3-tlv max-frame
This command configures an LLDP-enabled port to advertise its maximum frame
size. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
To Next Page
Loading...
