Edge-Core ES3510 - Exec Commands; Table 4-1 Command Modes

Command Line Interface
4-6
4
current mode. The command classes and associated modes are displayed in the
following table:
Exec Commands
When you open a new console session on the switch with the user name and
password “guest,” the system enters the Normal Exec command mode (or guest
mode), displaying the “Console>” command prompt. Only a limited number of the
commands are available in this mode. You can access all commands only from the
Privileged Exec command mode (or administrator mode). To access Privilege Exec
mode, open a new console session with the user name and password “admin.” The
system will now display the “Console#” command prompt. You can also enter
Privileged Exec mode from within Normal Exec mode, by entering the enable
command, followed by the privileged level password “super” (page 4-36).
To enter Privileged Exec mode, enter the following user names and passwords:
Table 4-1 Command Modes
Class Mode
Exec Normal
Privileged
Configuration
Global
*
Access Control List
Class Map
Interface
Line
Multiple Spanning Tree
Policy Map
Server Group
VLAN Database
* You must be in Privileged Exec mode to access the Global configuration mode.
You must be in Global Configuration mode to access any of the other configuration modes.
Username: admin
Password: [admin login password]
CLI session with the ES3510 is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the ES3510 is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#