8
SEASTAR Hydraulics
PS
H1 H2
R
C1 C2
R
ALIGNMENT
VALVE
SYSTEM INSTALLATION
SEASTAR POWER ASSIST
HELM PUMP MODEL
WHEEL TURNS WHEEL TURNS
& DISPLACEMENT CONFIG. C CONFIG. D
'PARALLEL' 'SERIES'
1.7 cu.in. per revolution 14.5 10
2.0 cu.in. per revolution 12.5 8
2.4 cu.in. per revolution 10.3 6
C
D
Hoses MUST be at least 6' in
length from the power assist to
the helm pump, or, from the
power assist to the cylinder(s).
NOTICE
Figure 5.
CAUTION
ALL hose connections MUST be
torqued to 15 ft-lb (20.34Nm).
DO NOT run the wires or hoses
in areas where the may come
in contact with battery acid or
excessive heat, i.e. engine
exhaust, manifolds or any
other area that may damage
the wires or hoses.
WARNING
To Next Page