Edimax CV-7428nS User Manual

16
III. BROWSER BASED CONFIGURATION INTERFACE
Once you have setup the wireless bridge as detailed in II. Quick Setup or the
included QIG, you can further configure the settings of the wireless bridge
anytime using the browser based configuration interface.
Note: Before you use the wireless bridge, please make
sure your computer is set to use a dynamic IP address.
This is a simple procedure, and step by step instructions
for how to do this, can be found in IV-1-1. How to
configure your computer to use a dynamic IP address.
Ensure that your wireless bridge is powered on and connected to your
computer via an Ethernet cable as explained in II-2. iQ Setup steps 1 – 2.
Please follow the instructions appropriate for your operating system:
Windows
Open a web browser (Internet Explorer is recommended) and enter
“http://www.edimax.go” into the URL bar. You will be prompted for a
username and password, please enter the default username “admin” and the
default password “1234”.
Mac:
Open a web browser and enter “http://www.edimax.go” into the URL bar. You
will be prompted for a username and password, please enter the default
username “admin” and the default password “1234”.

Edimax CV-7428nS Specifications

Power

power adapter voltage	DC 5V
power adapter current	1A

Operating Environment

humidity	10-90% (Non-condensing)
temperature range	0-40°C
temperature range in Fahrenheit	32 - 104°F

Wireless Standards

frequency band	2.4 GHz
IEEE 802.11n data rate	up to 300Mbps
IEEE 802.11g data rate	up to 54Mbps
IEEE 802.11b data rate	up to 11Mbps

Ports & Interfaces

LAN ports	5 x RJ-45
antenna type	2 x 2dBi external antennas
LED indicators	Power, Wireless, LAN ports

Weight and Dimensions

weight	155 grams
height	30 mm
width	127 mm
depth	96 mm