Edimax CV-7428nS User Manual

10
Hardware Installation for guidance on using the wireless bridge with your
network device.
II-2. iQ Setup
1. Connect one end of an Ethernet cable (included in the package contents) to
the Ethernet port on your computer. Connect the other end to an LAN port
on the wireless bridge.
2. Plug the power adapter into the device’s 5V power port, and plug the
adapter into a wall socket. The PWR LED should light up.
Note: Before you use the wireless bridge, please make
sure your computer is set to use a dynamic IP address.
This is a simple procedure, and step by step instructions
for how to do this, can be found in IV-1-1. How to
configure your computer to use a dynamic IP address.
3. Open a web browser, and you will be prompted for a username and
password.
Note: If you are not prompted for a username and
password, please enter “http://edimax.go” into the
URL bar.
4. Please enter the default username “admin” and the default password
“1234”.

Edimax CV-7428nS Specifications

Power

power adapter voltage	DC 5V
power adapter current	1A

Operating Environment

humidity	10-90% (Non-condensing)
temperature range	0-40°C
temperature range in Fahrenheit	32 - 104°F

Wireless Standards

frequency band	2.4 GHz
IEEE 802.11n data rate	up to 300Mbps
IEEE 802.11g data rate	up to 54Mbps
IEEE 802.11b data rate	up to 11Mbps

Ports & Interfaces

LAN ports	5 x RJ-45
antenna type	2 x 2dBi external antennas
LED indicators	Power, Wireless, LAN ports

Weight and Dimensions

weight	155 grams
height	30 mm
width	127 mm
depth	96 mm