35
III-4. WPS (Wi-Fi Protected Setup)
The WPS button is a quick and easy method to establish a secure wireless
connection between your network camera and your wireless router/access
point.
1. Press and hold the WPS button on your wireless router/access point for
the correct length of time to activate its WPS.
Please check the instructions for your
wireless router/access point for how long
you need to hold down its WPS button to
activate WPS.
2. Within two minutes, press the WPS/Reset button on the network camera
for 2 – 5 seconds to activate WPS. The green LAN LED will flash slowly to
indicate that WPS is active.
Take care not to hold the WPS/Reset
button too long and reset your network
camera (see I-7. Reset)
3. The devices will establish a secure wireless
connection. The green LAN LED will flash
quickly to indicate a successful WPS
connection.
To Next Page
Loading...
