EDT EX-RAY - CNC Bracket Mount Installation

CNC Bracket Mount:
Steering tube column diameters vary between golf cart manufac-
turers, ensure you have the correct diameter before starting the
project. (Example: the 1.50” EZ-Go tube uses 1.51” Clamp)
MODELS:
• EXRAY-MEZ EZ-Go 1.51”
• EXRAY-MEZ-EZ RXV 1.59”
• EXRAY-MCC ClubCar 1.66”
• EXRAY-MYAM Yamaha 1.71”
• EXRAY-MCCP ClubCar with
Plastic Tube 1.76”
• EXRAY-MXRT-850E (ELEC)
EXRAY-MXRT-850G (Gas)
ClubCar XRT with Plastic
Tube 1.76”
The parts shown include rubber
grommets inserted into the display
mounting holes 4mm x 12mm met-
ric screws. Metric Allen wrenches
will be needed (not included). (See
parts sheet)
The RED inserts are inserted into
the DEEP DRILLED HOLE sec-
tion. These are stops to prevent the
screws from damaging the display.
The RED FLAT BACK is farthest
away from the display.
15
Display Installation