Edwards T-STATION 85

Installaon
Installaon safety
WARNING:
Risk of injur
y or damage to equipment. Follow the safety instrucons and take note of all
appropriate precauons.
• When r
eferring to a manual supplied as a Supplementary Publicaon, all of the
WARNING and CAUTION instrucons in the manual must be obeyed.
• A suitably trained and supervised technician must install the T-Staon 85.
• Check that all the required parts are available and of the correct type before
commencing work.
• Ensure that the installaon technician is familiar with the safety procedures which
relate to the products pumped.
• Wear the appropriate safety clothing when coming into contact with contaminated
components.
• Isolate the other components in the system from the electrical supply so that they
cannot be operated accidentally.
• Do not reuse O-rings and co-seals if they are damaged.
• Dispose of components, grease and oil safely (refer to Disposal on page 32).
• Take care to protect sealing faces from damage.
• Leak tesng the system aer installaon is complete to ensure opmum vacuum
performance is recommended.
Unpack and inspect
1. Remove the outer cover and all packing materials, remove the protecve covers from
the inlet and outlet ports, inspect the system for any damage.
2. If the T-Staon 85 is damaged, nofy the supplier and the carrier in wring within
three days; state the item number of the T-Staon 85 together with the order number
and the supplier's invoice number. Retain all packing materials for inspecon. Do not
use the pump if it is damaged.
3. Check that the package contains the items listed in Table 1 on page 11. If any of
these items are missing, nofy the supplier in wring within three days.
4. If the pump is not to be used immediately, replace the protecve covers and store in
suitable condions as described in Storage on page 31.
Table 1
Checklist of items
Quanty Descripon Check
1 T-Staon 85
❏
1 CD instrucon manual P450-00-000
❏
1 Ultragrade 15 oil 1 litre (supplied with E2M1.5 only)
❏
1 Inlet seal (either trapped O-ring, co-seal or copper
c
ompression gasket suitable for the inlet ange type)
❏
D395-94-880A - Installaon
Page 11