SYSTEM SOFTWARE INSTALLATION 94
• User software is installed on the E-43A.
After installation, when the E-43A is connected to the customer’s network, users can access
the user software in the shared folder and install it on client computers.
If the installation hangs during this segment, possibly the time and date were not configured
in the BIOS following removal of the motherboard battery. To troubleshoot, see page 110.
12 Remove the User Software DVD when it ejects automatically.
13 When the “Insert Adobe/ Acrobat/ Enfocus Pitstop” message displays, insert the Acrobat/
PitStop DVD.
Installing Adobe Acrobat/PitStop takes about six minutes.
The E-43A reboots after installation, which takes approximately 45 minutes.
Note the following:
• If the message “Check power and cable” displays on the monitor (if available), verify that
the printer interface cable(s) are connected correctly to the copier/printer and the E-43A,
and that the copier/printer is on.
• Alternatively, if you do not have a monitor, you can press the Fiery icon on the printer, and
check to see whether the message appears under the Fiery controls on the printer.
14 If a monitor, mouse, and keyboard are present:
The Log On to Windows dialog box appears on the monitor under the Admin account. Type
Fiery.1 in the password field and then click OK.
NOTE: Ty pe Fiery.1 exactly. The password is case-sensitive; for example, fiery.1 will not work.
15 If you were able to back up the system configuration, restore the system configuration.
For more information, see Configuration and Setup, which is part of the user documentation
set.
16 Configure your system environment in Fiery Setup Wizard in WebTools or Command
WorkStation.
For more information, see Configuration and Setup.
17 If you were unable to back up the system configuration, configure Setup using one of the
following methods:
• Using the copier/printer touch panel: Assumes the E-43A is connected to the copier/
printer. From the copier/printer touch panel, press the Fiery icon. If Fiery icon does not
display, press the button
() on the upper right corner of the copier/printer touch
panel. Select Fiery tab > Setup, then configure Setup using the Configuration page you
printed earlier.
•
Using the copier/printer touch panel: Assumes the E-43A is connected to the copier/
printer. From the copier/printer touch panel, press the Services Home button. Then press
the Fiery icon, the Tools tab, and select Setup. Configure Setup using the Configuration
page you printed earlier.
To Next Page
Loading...
Need help?
General
