Commissioning
7.4 System settings
SCD 19102 / SMD 19102
Instruction Manual, 10/2011, A5E01588521A-004
75
2. If you reach the limit of the control range with the slider, you must carry out the "Force"
command with the selection "For static pictures" or "For motion pictures". The current
setting is then saved, and the slider set to the center of the control range. Once you have
set the signal frequency optimally, you can continue with the description.
6HOHFWಯ)RUPRWLRQSLFWXUHVರ
6HOHFWಯ)RUVWDWLFSLFWXUHVರ
To Next Page
Loading...
