19
SPINDLE SELECTION TABLES
R
6 SPINDLE SELECTION TABLES
6.1 L and TL Spindles (For use with RV1-L / RV2-L Viscometers).
Table 1: Spindle type L
a
a. Type L spindles are the standard spindles supplied with RV1-L/RV2-L Viscometers.
Spindle
speed (rpm)
Maximum
b
measurable viscosity (mPa•s)
b. The minimum recommended reading is 15% of the full scale value.
L1
c
c. The L1 spindle is used for low viscosity measurement. The spindle guard must be used with this spindle in
order to obtain correct viscosity readings. For higher accuracy when measuring low viscosity samples, use
the Adaptor for Low Viscosity Materials and the special cylindrical spindle (LCP); See “Spare parts and
accessories” on page 28.
L2 L3 L4
0.3 20 000 100 000 400 000 2 000 000
0.5 12 000 60 000 240 000 1 200 000
0.6 10 000 50 000 200 000 1 000 000
1 6000 30 000 120 000 600 000
1.5 4000 20 000 80 000 400 000
2 3000 15 000 60 000 300 000
2.5 2400 12 000 48 000 240 000
3 2000 10 000 40 000 200 000
4 1500 7500 30 000 150 000
5 1200 6000 24 000 120 000
6 1000 5000 20 000 100 000
10 600 3000 12 000 60 000
12 500 2500 10 000 50 000
20 300 1500 6000 30 000
30 200 1000 4000 20 000
50 120 600 2400 12 000
60 100 500 2000 10 000
100 60 300 1200 6000
200 30 150 600 3000
Resolution 1 mPa•s 1 mPa•s 10 mPa•s 10 mPa•s
2300_TMA_0377_00_01.book Page 19 Thursday, March 29, 2007 1:32 PM
To Next Page
Loading...
Need help?
General
