38
INSTRUCTIONS FOR RV2 VISCOMETERS
R
2. Type a name for the batch and then press the Return key.
3. The Model, Spindle type, Company and Operator will already be set from ‘Preferences’ when
ViscosityMaster was run for the first time. If necessary, amend these details as required.
4. Enter details in the Identifier and Notes fields. This information is used later, typically within
test reports.
The procedure for automatic mode now differs from the procedure for manual mode because of
‘Processes’ - see Setting up processes .
2300_TMA_0377_00_01.book Page 38 Thursday, March 29, 2007 1:32 PM
To Next Page
Loading...
Need help?
General
