Elcometer 456 - Page 57

55
* Contact Elcometer or your local Elcometer Supplier to arrange return.
Figure 34. Example error message - no probe is connected to gauge
UNSTABLE READING
a) External electro-magnetic interference. b) Gauge faulty.
a) Isolate from electro-magnetic interference. b) Return to Elcometer*.
VALUE TOO LARGE
Numerical error. Switch gauge off then on again.
If error persists contact Elcometer.
CALIBRATION Incorrect calibration calculation. Re-calibrate.
If error persists, return to Elcometer*.
LANGUAGE MEMORY
Software error. Return to Elcometer*.
Error message Causes Action to take
Op_456_2_English.book Page 55 Friday, February 17, 2006 3:35 PM