Installation Information
2-10
Wave-Touch™ Installation Cycle
1. After plugging in the washer the first time:
Wake up the washer by pressing any button and
then follow the prompts on the LCD User Interface,
including language selection. The Installation Cycle
will automatically test for if the water has been
turned on.
2. At cycle completion, the LCD window may display
INSTALL PASS!, meaning the washer is properly
installed and ready for use. If it prompts an action
such as NO WATER, CHECK HOSES or CALL
SERVICE 877-435-3287, review the installation
steps and make the necessary corrections before
attempting to use the washer.
3. The washer will exit the Installation Cycle and return
to normal operation the next time the washer is
used.
IQ -Touch™ Installation Cycle
1. Empty washer’s drum and close door.
2. After you plug in the washer the first time:
wake up the washer by pressing any button, rotate
cycle knob to hand wash cycle, press the start button
and then the cancel button.
3. Wake up the washer again by pressing any button,
then immediately and simultaneously press and hold
both the eco friendly and my favorite buttons for 5
seconds, or until the LCD display changes.
4. The LCD window will display INSTAL CYCLE and
show estimated time of cycle completion. Press
the START button. The Installation Cycle will
automatically test for if the water has been turned
on. At cycle completion, the LCD window may
display INSTAL PASS!, meaning the washer is
properly installed and ready for use. If it prompts an
action such as NO WATER, CHECK HOSES or Call
Service 877-435-3287, review the installation steps
and make the necessary corrections before you
attempt to use the washer.
5. The washer will exit the Installation Cycle and return
to normal operation the next time the washer is
used.
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run
the washer through a washing cycle, press the
cancel button to put the unit to sleep and then
rewake it immediately, to continue the normal
operating mode.
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run
the washer through a washing cycle, press the
cancel button to put the unit to sleep and then
rewake it immediately to continue the normal
operating mode.
To Next Page
Loading...
