Installation Information
2-19
Dryer Stacking Instructions
Kit Components: (See Figure 2-40)
1 Dryer Stacking Instructions.
A. 1 Front bracket with adhesive strip.
IMPORTANT - DO NOT remove RED backing from
adhesive strip until instructed to do so.
B. 2 rear brackets.
C. 2 strips of self-adhesive protective film.
D. (6) #10 (16 x 3.75) screws.
Preparing to Stack
1. Be sure there is adequate space to stack dryer
on top of washer.
2. You will need a screw driver with a #2 square
bit, isopropyl alcohol and a clean cloth.
3. Read washer and dryer installation instructions
packed with each appliance prior to stacking.
4. Be sure washer and dryer are both unplugged.
Preparing Dryer for Stacking
1. If already installed, disconnect dryer from electrical
and gas connections and exhaust venting. On
models with Steam Option, disconnect water supply
to dryer.
2. Protect floor with cardboard or other covering and
carefully tip dryer onto its back. (See Figure 2-41)
3. Remove adjustable leveling legs and save for future
use.
4. Attach front stacking bracket to dryer front with
(2) - #10 screws. (See Figure 2-42)
5. Carefully return dryer to upright position.
B
C
D
Figure 2-40.
Figure 2-42.
Figure 2-41.
DO NOT REMOVE RED BACKING FROM
ADHESIVE STRIP YET!
DO NOT REMOVE ANY EXISTING SCREWS FROM
FRONT PANEL!
To Next Page
Loading...
