Installation Information
2-17
Reversing Trim Ring
1. Trim ring orientation is marked on the back.
2. Remove the trim ring cover plate. To remove the
cover plate from the right, pivot point is up. To
remove the cover plate from the left, pivot point is
down. (See Figure 2-36)
Reinstalling Trim Ring
1. Close the door.
2. Orient the trim so 12 position is approximately ¾” to
the left of top center. The opening in the trim ring
should be on the hinge side.
3. Insert the trim ring in the slots and rotate it
clockwise approximately ¾”. (See Figure 2-37)
UP
Reinstalling Trim Plug
1. Open the door to a 90 degree angle.
2. Install the trim plug with 1 long, course thread,
panhead screw. (See Figure 2-38)
3. Plug in washer and continue operation.
Figure 2-36.
Figure 2-37.
Figure 2-38.
To Next Page
Loading...
