Flight Data Screen Menu (see section 4.0): The Flight
Data Screen Menu provides access to screens designed to
assist the pilot in aircraft and engine operation, flight
management, procedures, rules and regulations and a wealth of
other information. All of the Flight Data Screens are displayed
against a blue background and will be displayed on the left side
of the MVP screen. A full set of annunciators and five primary
engine instruments will be displayed on the right side of the
screen against a black background. If any function on the
Main or System Screen goes into the red or yellow, the
appropriate annunciator will blink, the external warning light
will blink and an appropriate voice warning will be played. In
this way the pilot is immediately alerted of a potential problem
and should view the appropriate screen for further information.
Setup and Control Screen Menu (see section 5.0): The
Setup and Control Screen Menu provides access to screens containing parameters that the pilot may want to
change from time to time during a flight (brightness control, screen button setup, etc.).
System Configuration Screens (see section 6.0): The System Configuration Screen Menu provides a list of
screens used to configure the MVP for almost any aircraft. These screens allow you to setup functions, screens,
instrument markings, limitations, weight and balance setup, flap and trim calibration, fuel tank calibration and other
system setup requirements. The “MVP-50T Initial Setup
Checklist” will guide you through the necessary steps to set
up the MVP for your aircraft. The “MVP-50T Initial Setup
Checklist” is provided on a separate blue tag-board.
All of the System Configuration Screens will be displayed
with a black background and the annunciators and engine
instruments will not be displayed. If the engine is running, you
will need a password to enter the System Configuration
Screen Menu. If the engine is not running, you may enter the
System Configuration Screen Menu without a password and
view the data on the various screens, but you will not be able
to change any data until you have entered the correct
password.
4
To Next Page
Loading...
Need help?
General
