5.4 “System Configuration Screens Menu:”
The System Configuration Screens Menu allows you to access a number of setup and configuration screens that are
not used during normal engine operation. When you enter the System Configuration Menu the engine instruments
will not be displayed and, therefore, it is not recommended to access this menu during engine operation. If the
engine is running and you access the System Configuration Screens Menu, you will be asked for a password. If the
engine is not running, you may view any of the system configuration screens but you will not be able to change any
data until you have entered the correct password. A description of the system configuration screens is provided in
the next section of this manual.
6.0 System Configuration Screens
The System Configuration Screens provide access to setup and calibration data. By accessing this data you can
properly set up the MVP to work with your aircraft. It is important you understand the operation of each screen
and function before you change any data. If you do not have the knowledge to properly change an item, seek help.
All changes must be verified that they provide proper MVP operation.
WARNING: The System Configuration Screens
allow you to change important setup and calibration
data that may affect the way the aircraft is operated.
If any data is changed in any one of the System
Configuration Screens, it is important to verify that
the change is proper for your aircraft. If any changes
have been made, back up the MVP configuration files
to the USB Data Stick.
You must set a unique password to protect all of the
calibration and setup data in the MVP. If setup or
calibration data is inadvertently or improperly
changed, the MVP could display inaccurate readings
that may lead to improper operation of the aircraft or
engine. This could result in engine damage and/or an
emergency situation. Verify that the MVP is working
properly for the aircraft and engine for which it is
intended BEFORE the aircraft is released for normal operation.
If the engine is not running, you may view any of the system configuration screens but you will not be able to change
any data until you have entered the correct password. Once you have entered the correct password you will not be
asked for it again until power to the MVP has been cycled. The factory default password is “0100.”
The following describes the operation for each System Configuration Screen:
6.1 “System Management” Section:
This section provides screens that allow you to perform system functions. The following screens are available:
24
To Next Page
Loading...
Need help?
General
