Electronics Line iconnect - Page 42

7. Advanced System Operation
36
iConnect User Manual

Todeleteamessage:
1. FromtheServicemenu,selectMessages,DeleteMessage[7023];OK?
isdisplayed.
2. Press;themessageisdeleted.
The Record and Play options can also be accessed via a convenient shortcut
withoutneedingtoenteravalidusercode.
ToaccesstheRecordMessageoptionfromStandbymode,press then.
ToaccessthePlayMessageoptionfromStandbymode,press then.
Siren Tests
Totesttheexternalwirelesssiren:
 FromtheServicemenu,selectWLSirenTest[703];thewirelesssirenis
soundedbriefly.
Totestthebuilt‐insiren:
 FromtheServicemenu,selectSirenTest[704];thebuilt‐insirenis
soundedbriefly.
Interface Test
The Interface test enables you to check if the speaker,  LEDs and LCD are functioning
correctly.
Totestthesysteminterface:
 FromtheServicemenu,selectInterfaceTest[705];ashortsequenceof
chimesaresoundedfromthespeaker,allLEDsflashandthe LCDis
testedonallconnectedLCDkeypads.
Walk Test
Walk Test mode enables you to test all the sensors registered to your system without
triggeringanalarm.
ToinitiateWalkTestmode:
1. FromtheServicemenu,selectWalkTest[706];alistofregisteredsensors
appears.
2. Triggereachsensor;whenthesystemreceivesasuccessfultransmission
froma
sensor,thesensorisremovedfromthelist.
3. Whenallthesensorsareremovedfromthelist,EndWalkTestisdisplayed.
4. PresstoexitWalkTestmode.
Transmitters
TheTransmittersmenuofferstwoutilities,TXListandTXTest.
TheTXListcomprisesallregisteredtransmittersandtheirlastreportedstatus.
ToviewtheTXlist:
1. FromtheServicemenu,selectTransmitters,TXList[7071];thefirst
transmitteronthelistisdisplayed.