Introduction EEC-0003 V1.2
Introduction
Do not operate this crane until you have read and thoroughly understand this
manual, the accompanying Association of Equipment Manufacturers āSAFETY
MANUAL FOR OPERATING AND MAINTENANCE PERSONNELā, all decals on the
crane and you have been properly trained by an experienced, qualified crane operator.
The information in these manuals is a guide to assist qualified personnel in safe
operation and maintenance of this crane and is not a substitute for training, experience
and common sense.
If there is a question on application and/or operation, contact the Product Safety
and Reliability Department at Elliott Equipment Company. If an Elliott Crane is involved
in a personal injury or property damage incident notify the Product Safety and Reliability
Department as soon as possible. Have the model and serial number and details of the
incident recorded prior to contacting the factory.
Elliott Equipment Company
4427 South 76th Circle
Omaha, NE 68127-1806
Ph. 402-592-4500 FAX 402-592-4553
e-mail info@elliottequip.com
www.elliottequip.com
Always refer to the latest version of ANSI/ASME B30.5 standards for safe
operation, inspection and maintenance of this crane. Federal, state and local laws, rules
and regulations along with safety codes and insurance requirements take precedence
over any information in this manual.
See the CIMA manual for correct, safe operation near power lines and hand
signals.
READ, UNDERSTAND AND FOLLOW ALL SAFETY LABELS
BEWARE OF OVERHEAD POWER LINES
UNDERSTAND AND NEVER ATTEMPT EXCEEDING CRANE LOAD CHARTS
NEVER EXCEED OPTIONAL PLATFORM CAPACITY AND AREAS OF OPERATION
BEWARE OF ADVERSE WEATHER AND GROUND CONDITIONS
To Next Page
Loading...