BA-en-3041-2008_PC 27
3.9.2 ModbusTCP (optional)
The generators of the POWER CHARGER family can be integrated into
an existing LAN network using the TCP/IP standard ModbusTCP protocol.
All variants with this option support the following functions:
• 10/100 Mbit/s transmission
• DHCP protocol for setting the IP address (active by default)
• Static IP address is possible
• Cyclic retrieval of process data
• Setting and reading of the parameter set
• LED output of the network and connection status
A complete description of supported commands and assignment of pro-
cess data, parameters etc. in the respective registers is available in the
Downloads area at www.eltex.com/support/download service.
Caution!
The generator must be connected to the network by means of suitable,
shielded cables; the shield must be contacted at an appropriate place on
both ends. We recommend using cables of category Cat 5e or higher.
Fig. 15:
Connetor pin
assignment
Plug connector
M12x1 D-coded
1 Tx +
2 Rx +
3 Tx -
4 Rx -
2 x Socket female
F00055y
To Next Page
Loading...
