BA-en-3041-2008_PC 75
71 CANopen®
node monitoring error
• Check node monitoring of the CANopen®
master.
• Clear the warning.
• If this warning occurs again, send in the
device for repairs.
72 Error during
re-connection
• Check bus cabling.
• Check baud rate.
• Clear the warning.
• If this warning occurs again, send in the
device for repairs.
81 Parameter value below
minimum
• Parameter was automatically corrected to
minimum.
• Clear the warning.
82 Parameter value above
maximum
• Parameter was automatically corrected to
maximum.
• Clear the warning.
84 Invalid parameter value
• Parameter was not changed. Transmit correct
value.
• Clear the warning.
Warning
number
Cause Measure
To Next Page
Loading...
