ELTEX SMG-4 - Page 164

164 SMG digital gateway
address without numbering schedule
routing. The call is routed directly to
the address specified in the "contact"
header of reply 302 received from
the redirection server. First,
redirection 302 should be configured
(the redirection 302 command).
refer
<REFER>
enable/disable
Enable/disable call transfer with
REFER
register delay
<REGEXP>
500-5000
The minimum interval between the
Register messages that is used to
protect from high traffic caused by
simultaneous registration of a large
number of subscribers
register expires
<REGEXP>
90-64800
Set the time interval for registration
regmode
<REGMODE>
none/
trunk-mode/
Set the type of registration on an
upstream server
reliable_1xx_
response
<ON_OFF>
on/off
When the option is enabled, the
INVITE request and 1хх class
provisional responses will contain the
require: 100rel option, which
requires assured confirmation of
provisional responses
remote name in
contact header
<ON_OFF>
on/off
insert displayed name in Contact
header
route_mode
<ROUTE_MODE>
RURI/
TO/
defaultCdPN
Set a routing mode: by RURI, by the
TO field, CdPN by default
routing_profile
<prof>
0-127
Select a scheduled routing profile
RTCP control
<RTCP_c>
2-255
Set the number of time periods
(RTCP period) to wait for RTCP
protocol packets from the opposite
party
RTCP period
<RTCP_p>
5-255
Set the time period in seconds, after
which the device sends control
packets via the RTCP protocol.
RTP loss silence
<RTP_TIMEOUT_SILENCE>
1-30
Set the RTP packet timeout for the
silence suppression option. The
coefficient determines how many
times the value of this timeout is
larger than RTP-loss timeout
RTP loss timeout
<RTP_TIMEOUT>
10-300/
off
Set an RTP packet timeout
sdp_in_18x
<ON_OFF>
on/off
Always send SDP in provisional
replies
show
Show SIP-T interface information
sipcause profile
<SIPCAUSE>
[0-63]/
none
Select a compliance profile for Q.850
causes and sip-replies
sipdomain
<SIPDOMAIN>
String, 63
characters max.
IP address in the
AAA.BBB.CCC.DDD
format
Set an address of the registration
domain
source port check
<ON_OFF>
on/off
Control reception of signalling traffic
from the UDP port specified in the
port setting